TM10-3930-641-34-2
HYDRAULIC PUMP REMOVAL/INSTALLATION (CONT)
(Sheet 7 of 8)
LOCATION/ITEM
ACTION
REMARKS
5.
Clamp below elbow on supply line Tighten.
6.
Hydraulic line (12)
Connect to rear of pump.
7.
Heat shield (11)
Place in position.
8.
Cal)screws (10) to hold heat shield Install.
9.
Air cleaner housing
Fasten hoist and install.
10. Filter group (9)
Install by following:
a.
Filter group (9)
Fasten hoist and place in position.
b.
Three heat shield capscrews Install.
c.
Four position capscrews
Install.
11. Transmission and pilot filter
Install in filter base.
systems filters
12. Four capscrews (6) that hold air
Install.
cleaner housing to filter base frame
TA099157
Go on to Sheet 8
7-11
