TM 10-3930-641-34-2
TEE TEST PROCEDURE FOR HYDRAULIC SYSTEM (CONT)
(Sheet 25 of 27)
LOCATION/ITEM
ACTION
REMARKS
oil pressure. Put the control levers in HOLD
position. Open the filler cap for the hydraulic
tank to release any tank pressure and close the
cap. Use the Blocking Plate Assemblies, to
block the head end of the right tilt cylinder and
the rod end of each auxiliary cylinder as
needed.
TEST 30
TEMPERATURE
1.
Manual load valve
Open fully.
2.
Engine
Start and run at any rpm.
3.
Control lever
Move to LOWER position.
4.
Oil temperature
Record.
TEST 31
TILT TILTBACK FLOW RATE
1.
Control lever
Move to TILTBACK position
2.
Engine
Run at 2000 rpm.
Go on to Sheet 26
7-148