TM 10-3930-675-10-2
ERROR CODES - CONTINUED
0020 00
Table 4. Error Codes - Continued.
ERROR
DISPLAY
CODE
LAYOUT
DRIVER ACTION
ERROR CODE EXPLANATION
VEHICLE LIMITATIONS
Select Steering
Information/Maintenance
None.
Mode
347
No valid
steering
program
selected.
Stop Vehicle
Steering Valve Solenoid
Stop vehicle by switching to
NEUTRAL.
Abort mission.
This error code occurs if the
Steering system will not
Notify maintenance.
resistance differs from the preset
operate properly.
value.
350
Wheel 1
351
Wheel 2
352
Wheel 3
353
Wheel 4
Stop Vehicle
Start-up Failure in Steering
Stop vehicle by switching to
System
NEUTRAL.
Abort mission.
Steering system will not
Notify maintenance.
This error code is caused by incorrect
operate properly.
parameter settings in steering
computer.
354
Wheel 1
355
Wheel 2
356
Wheel 3
357
Wheel 4
Press RESET
EEPROM Parameter Error in
Fully operational.
399
Steering Computer
History storage of error codes
Finish mission.
may not be possible.
Notify maintenance.
One or more parameter values inside
EEPROM are out of range.
Stop Vehicle
Warning - Degraded
Transmission will not go into
Operation
neutral automatically.
401
Press RESET.
Finish mission.
Digital output short circuit -
Notify maintenance.
"Enable driving" (no neutral gear
from steering ECU).
Cables defective.
Finish Mission
Information/Maintenance
Control lamp on steering
404
Notify maintenance.
selection switch is not
Digital output short circuit -
working.
"Control lamp, front wheel steer-
ing."
Cables defective.
0020 00-18
