TM 10-3930-675-10
0005 00-24
OPERATION UNDER USUAL CONDITIONS - CONTINUED
0005 00
OPERATE LIGHTS, HORN, AND FRONT WINDSHIELD WIPER/WASHER
NOTE
If the engine is not running, ignition switch must be in ON position for the lights and horn to work.
1.
Place ignition switch to the ON position.
2.
Move accessory control lever FORWARD for LEFT directional signal and REARWARD for RIGHT directional signal.
3.
Lift up on accessory control lever to FLASH headlights.
4.
Push down on accessory control lever for headlight HIGH BEAM.
5.
Press button at the end of the accessory control lever for HORN operation.
6.
Rotate accessory control lever knob for windshield wiper and push for windshield washer functions.
SHUT DOWN ENGINE
1.
Apply the parking brake.
2.
Retract and fully lower boom.
3.
Place transmission control lever in Neutral (N).
4.
Allow the engine to run for 1/2-1 minute at idle.
CAUTION
Never turn master battery switch to OFF when the engine is running. Damage to voltage regulator may result.
5.
Stop the engine by turning ignition switch to 0 position.
6.
If the truck will not be used for a longer period, place master battery switch to OFF.
ACCESSORY
CONTROL LEVER
