TM 10-3930-675-100005 00-25OPERATION UNDER USUAL CONDITIONS - CONTINUED0005 00OPERATE PORTABLE FIRE EXTINGUISHERWARNINGDischarging large quantities of dry chemical fire extinguisher in cab may result in temporary breathing diffi-culty during and immediately after the discharge event. If at all possible, discharge fire extinguisher fromoutside the cab. Ventilate cab thoroughly prior to reentry.NOTEThis is a type B or C fire extinguisher. Use on oil and electrical fires only.1.Remove fire extinguisher from bracket located to the right rear of the operator’s seat.2.Hold fire extinguisher upright. Point nozzle toward base of fire and pull safety pin.3.Squeeze lever, discharging chemical at base of fire. Use a side-to-side motion to spread the chemical.4.After using fire extinguisher, notify Organizational Maintenance.FORKLIFT KIT INSTALLATION1.General.a.The forklift kit attaches to the tophandler twistlocks and hydraulic system. The forklift is attached with the kit in afolded configuration.b.The procedure requires two personnel: one person in the cab operating the joystick controls; one person installing/removing retaining pins, connecting the hydraulic quick disconnect hoses, and ground guiding the operator.2.InstallingForkliftKit.a.Position tophandler directly over and level with forklift kit.b.Lower tophandler onto forklift kit and secure with twistlocks.TOPHANDLERFORKLIFT KIT
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
