Error Code 1313 - Injector Circuit Failure -cont

Error Code 1312 - Injector Circuit Failure -cont - TM-10-3930-675-20-1_126

Error Code 1313 - Injector Circuit Failure -cont - TM-10-3930-675-20-1_128

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
100

TM 10-3930-675-20-1 0007 00-9 ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED 0007 00 Table 3. Error Code 1313 - Injector Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1313 - Injector Circuit Failure - Continued b. Check actuator harness, actuator harness connector, and 15-pin connector for dirt or moisture in or on connector and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 2. Place ignition switch to OFF position and disconnect actuator harness and sensor harness from engine ECU and actuator harness from 15-pin connector at front of engine below rocker arm cover. Perform the following resistance checks. a. Measure resistance from actuator harness connector pin 6 to all other pins in actuator harness connector. Resistance should be greater than 100k ohms. a. If resistance is not as specified, repair or replace connectors (WP 0111 00). b. If internal actuator harness requires replacement, notify SRA. >100K OHMS

Privacy Statement
Press Release
Contact