TM 10-3930-675-20-1 0007 00-14 ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED 0007 00 Table 4. Error Code 1314 - Injector Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error  Code  1314  -  Injector  Circuit  Failure  - Continued 3. Place  ignition  switch  to  OFF position and disconnect actuator  harness  from  engine ECU.   Remove   rocker   arm cover (WP 0051 00). Disconnect  internal   actuator harness from 15-pin connector. a. Inspect    actuator    harness connector,     engine     ECU connector, and 15-pin connector for dirty, corroded,     bent,     broken, pushed back, and extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check     actuator     harness connector,     engine     ECU connector, and 15-pin connector for dirt or moisture in or on connector and for missing or damaged connector seals. Remove dirt  and  moisture from connector.  Replace  missing  or damaged  connector  seals  (WP 0111 00). 4. Place  ignition  switch  in  OFF position and disconnect internal actuator harness from 15-pin connector and from no. 6 injector solenoid. a. Measure resistance from 15- pin connector pin 11  to all other   pins   in   connector. Resistance should be greater than 100k ohms. a.  If     resistance     is     not     as specified,   repair   or   replace connectors (WP 0111 00). b. If   internal   actuator   harness requires   replacement,   notify SRA. b. Measure resistance from 15- pin connector pin 12 to all other   pins   in   connector. Resistance should be greater than 100k ohms. a.  If     resistance     is     not     as specified,   repair   or   replace connectors (WP 0111 00). b. If   internal   actuator   harness requires   replacement,   notify SRA. 5. Place  ignition  switch  to  OFF position and, with rocker arm cover    removed,    disconnect internal actuator harness from injector solenoid.