Error Code 1582 - Fuel Inlet Restriction Sensor Circuit Failure - Cont

Error Code 1582 - Fuel Inlet Restriction Sensor Circuit Failure - Cont - TM-10-3930-675-20-1_415

Error Code 1582 - Fuel Inlet Restriction Sensor Circuit Failure - Cont - TM-10-3930-675-20-1_417

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
380

TM 10-3930-675-20-1 0023 00-14 ENGINE FUEL PRESSURE SENSORS AND CIRCUITS TROUBLESHOOTING - CONTINUED 0023 00 Table 3. Error Code 1582 - Fuel Inlet Restriction Sensor Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1582 - Fuel Inlet Restriction Sensor Circuit Failure - Continued 9. Place ignition switch to OFF position and disconnect actuator harness connector from engine ECU. a. Inspect harness connector and engine ECU connector for dirty, corroded, bent, broken, pushed back, and extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check harness and engine ECU for dirt or moisture in or on the connector and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 10.Place ignition switch in OFF position, disconnect actuator harness connector from engine ECU, and disconnect fuel inlet restriction sensor from engine harness. a. Measure resistance from actuator harness connector pin 29 to pin A (or 1) of 3 pin connector. Resistance should be less than 10 ohms. a. If resistance is not as specified, repair or replace connectors (WP 0111 00). b. If engine harness requires replacement, notify SRA. b. Measure resistance from actuator harness connector pin 28 to pin C (or 3) of 3 pin connector. Resistance should be less than 10 ohms. a. If resistance is not as specified, repair or replace connectors (WP 0111 00). b. If engine harness requires replacement, notify SRA.

Privacy Statement
Press Release
Contact