TM 10-3930-675-20-1 0041 00-4 BOOM IN/OUT TROUBLESHOOTING - CONTINUED 0041 00 Table 2. Error Code 130 - Overload Protection System Failure Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error  Code  130  -  Overload  Protection  System Failure Overload protection system failure  occurs  due  to  an  earlier failure (error codes 131-136) on any   component  related   to  the overload protection system. Hydraulic speeds are limited and the error code will flash on the display every 5 seconds. Perform troubleshooting procedures for the original error code (error codes 131-136). Table 3. Error Code 160 - Extension Cylinder Boom IN Control, Wiring Circuit Failure Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 160 - Extension Cylinder Boom IN Control, Wiring Circuit Failure 1.  Remove   ECU   (790)   cover from operator’s seat base and slide ECU mounting tray out (WP 0079 00). 2.  Check ECU (790) connector 2 and tray grounding leads for proper connection. a. Connect any loose or disconnected connections. Push  ECU  mounting  tray  in and install cover. b. Repair or replace any damaged connectors (WP 0111 00). Push ECU mounting tray in and install cover. 3.  Check voltage (20-25V) between connector X158 pin 5 and pin 6. If voltage is not present, check continuity between: ECU (790) connector    2    pin    12    and connector X158 pin 6; between ECU (790) connector    2    pin    10    and connector  X159  pin  1;  and between connector X159 pin 1 and connector X158 pin 5. If    continuity   is    not    present, repair or replace connectors (WP 0111 00). DIAG SERVO 10(13)         OUTPUT/INPUT BOOM IN    0mA    0mA BOOM OUT   0mA    0mA