BOOM IN/OUT TROUBLESHOOTING - TM-10-3930-675-20-1

BOOM LIFTING/LOWERING TROUBLESHOOTING - CONT - TM-10-3930-675-20-1_588

Table 1. Error Code 127 - Joystick-to-ECU (790) Failure Troubleshooting Procedures - Cont

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
545

TM 10-3930-675-20-1 0041 00-1 BOOM IN/OUT TROUBLESHOOTING 0041 00 THIS WORK PACKAGE COVERS Error Code 127 - Joystick-to-ECU (790) Failure Error Code 130 - Overload Protection System Failure Error Code 160 - Extension Cylinder Boom IN Control, Wiring Circuit Failure Error Code 161 - Extension Cylinder Boom IN Control, Component Failure Error Code 163 - Extension Cylinder Boom OUT Con- trol, Wiring Circuit Failure Error Code 164 - Extension Cylinder Boom OUT Con- trol, Component Failure INITIAL SETUP References TM 10-3930-675-10 Current Supply (A34738.0200) (WP 0199 00-31) ECS Electrical Servo (A34648.0200) (WP 0199 00-5) NOTE • Refer to WP 0004 00 for additional troubleshooting guidance, information, and illustrations that locate critical components. • Refer also to illustrations at end of work package for component location. Table 1. Error Code 127 - Joystick-to-ECU (790) Failure Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 127 - Joystick-to-ECU (790) Failure 1. Enter “DIAG SERVO 5 (13)” menu and check BOOM IN/ OUT voltage. If voltage is out of range, perform the following steps: a. Remove ECU (790) cover from operator’s seat base and slide ECU mounting tray out (WP 0079 00). DIAG SERVO 5(13) LIFT/LOWER 5.00V BOOM IN/OUT 5.00V

Privacy Statement
Press Release
Contact