TM 10-3930-675-20-20111 00-7ELECTRICAL GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED0111 00RING TERMINAL REPAIR - CONTINUED 2.Cut heat shrink tubing (33) to length sufficient to cover tabs (36 and 37) of ring terminal (38) and ¼ in (6 mm) of wire(34).3.Slide heat shrink tubing (33) back on wire (34).4.Using wire stripping tool, strip insulation of wire (34) to expose proper length of metal strands (35).5.Using crimping tool, securely crimp tabs (37) of ring terminal (38) over metal strands (35).6.Using crimping tool, crimp tabs (36) of ring terminal (38) over insulation of wire (34).7.Slide heat shrink tubing (33) over tabs (36 and 37) of ring terminal (38).8.Using heater gun, apply heat to heat shrink tubing (33) until tubing snugly conforms to ring terminal (38) and insulationof wire (34).SPLICING WIRESNOTEThe selection of crimping tool and type of splice connectors is optional. High quality splice connectors canbe expected to last the life of the vehicle.1.Inspect each end of wire (39). Trim insulation and metal strands (40) of wire back, as necessary, to ensure integrity ofwire.2.Using wire stripping tool, strip each end of wire (39) to expose length of metal strands (40) to suit type of splice connec-tor (41) used.NOTEPerform steps 3 and 4 at each end of splice connector.3.Insert metal strands (40) of wire (39) fully into splice connector (41).4.Using crimping tool, securely crimp splice connector (41) to metal strands (40) of wire (39).3334353637383940414039
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
