TM 10-3930-675-20-20111 00-5ELECTRICAL GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED0111 00RECEPTACLE CONNECTOR REPAIR - CONTINUED5.Using wire stripping tool, strip insulation of wire (16) to expose ¼ in (6 mm) length of metal strands (17).6.Using crimping tool, securely crimp tabs (19) of receptacle (20) over metal strands (17).7.Using crimping tool, crimp tabs (18) of receptacle (20) over insulation of wire (16).8.Slide connector (15) forward over receptacle (20) until locking tab of receptacle snaps into place.WATERPROOF CONNECTOR REPAIR1.Remove end cover (27) and gasket (26) from front of connector (25).2.Remove seal (21) from rear of connector (25) and slide seal back on wire (22).NOTE•Perform steps 3 thru 9 for each wire of connector.•Tag wires for installation.3.Using pin removal tool, insert tool into front of connector (25) and depress locking tab of connector.4.Remove wire (22) with pin (24) from rear of connector (25).5.If defective, remove pin (24) from wire (22) by cutting thru wire just behind pin.6.Using wire stripping tool, strip insulation of wire (22) to expose ¼ in (6 mm) length of metal strands (23).15161718192021222324252627
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business