TM 10-3930-675-20-2
0120 00-2
PARKING BRAKE PADS MAINTENANCE - CONTINUED
0120 00
REMOVAL - CONTINUED
3.
Retract adjustment cylinder (2) into piston (9) by prying between adjustment cylinder and one brake pad (10).
NOTE
Only one of two bolts needs to be removed in order to remove brake pads.
4.
Remove cotter pin (13) from one of two castle nuts (14). Discard cotter pin.
5.
Remove castle nut (14) and bolt (12) from parking brake housing (3) and parking brake bracket (1).
NOTE
One brake pad is held in place by a magnet.
6.
Remove two brake pads (10) from parking brake housing (3) and parking brake rotor (11).
CLEANING AND INSPECTION
1.
Clean brake pads with detergent, clear water, and rags. Rinse with clear water and dry surfaces with rags.
2.
Check for damage to brake pads. Replace if damaged.
3.
Check thickness of brake lining of each brake pad, using a feeler gage as a basis for comparison. Brake lining must be at
least 0.080 in (2 mm) thick. If brake lining thickness is less, discard brake pad.
4
5
6
7
8
9
12
13
14
1
2
3
10
11
10
