TM 10-3930-675-24-1
TROUBLESHOOTING PROCEDURES (NON-ERROR CODE) - CONTINUED
0007 00
Table 2. Electrical Troubleshooting Procedures (Non-Error Code) - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. Stoplight(s) Do Not Operate When Brake Pedal
b. If breaker does not reset, use
is Pressed - Continued.
the wiring diagram to check
circuit for short to ground (WP
shorted or grounded harnesses
(WP 0113 00).
c. Replace damaged or faulty
circuit breaker (WP 0074 00).
3. Inspect stoplights for damage a. Replace burned out lamps
or burned out lamps.
(WP 0098 00).
b. Replace damaged stoplights
(WP 0098 00).
4. Check
stoplight
wiring Repair or replace damaged
harnesses and connectors for harnesses or connectors (WP
damage.
0113 00).
5. Check voltage (24V) at X26 a. If no voltage (24V) is found,
pin 2 and 3 with the ignition on
remove the kick panel in front
and the brake pedal depressed.
of the steering column and
(Ensure the hydraulic brake
check brake light switch 216
pressure is built up.)
for
while
depressing the brake pedal
(WP 0098 00).
b. Replace damaged or faulty
switch (WP 0098 00).
c. If switch is good, use the
wiring diagram to check the
continuity of wires 262 and
263 (WP 0048 00-36).
d. Repair or replace damaged
wires or connectors (WP 0113
00).
6. Check voltage (24V) at XK13 a. If no voltage (24V) is found,
pin 6 and 9 with the ignition on
remove relay 3010 and test
and the brake pedal depressed.
(WP 0113 00).
(Ensure the hydraulic brake b. Replace damaged or faulty
relay (WP 0074 00).
pressure is built up.)
0007 00-23
