TM 10-3930-675-24-1
TROUBLESHOOTING PROCEDURES (NON-ERROR CODE) - CONTINUED
0007 00
Table 2. Electrical Troubleshooting Procedures (Non-Error Code) - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. Headlight(s) (High or Low Beam) Do Not
b. Repair or replace damaged
Operate When Switch is Turned On -
wires or connectors (WP 0113
Continued.
00).
7. Check voltage (24V) at X19 a. If no is voltage is found, check
pin 6 and 7 with the headlight
continuity of wires 195, 196,
switch turned on and operating
and 197 (WP 0048 00-41).
the HI/LO beams.
b. Repair or replace damaged
wires or connectors (WP 0113
00).
c. Check accessory control lever
for damage and continuity
(WP 0048 00-41).
d. Replace damaged or faulty
accessory control lever (WP
0234 00).
8. Check voltage (24V) at X11 a. If no voltage is found, use the
pin 7 and X12 pin 6 with the
wiring diagram to check
headlight switch turned on and
circuit breakers F20 and F21
in LOW beam.
and the continuity of wires
A196, A196A, A117, and
A126 (WP 0048 00-41).
b. Repair or replace damaged
wires or connectors (WP 0113
00).
c. Replace damaged or faulty
circuit breaker (WP 0074 00).
9. Check voltage (24V) at X11 a. If no voltage is found, use the
pin 8 and X12 pin 8 with the
wiring diagram to check
headlight switch turned on and
circuit breakers F18 and F19
in HIGH beam.
and the continuity of wires
A197, A197A, A118, and
A128 (WP 0048 00-41).
b. Repair or replace damaged
wires or connectors (WP 0113
00).
c. Replace damaged or faulty
circuit breaker (WP 0074 00).
0007 00-20
