TM 10-3930-675-24-1
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0008 00
WARNING
Injector solenoids receive high voltage when engine is operating. To avoid personal injury or death
from electrical shock, do not wear jewelry or damp clothing, and do not touch injector solenoids or
solenoid wires when engine is operating.
Table 9. Error Code 1324 - Injector Circuit Failure Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1324 - Injector Circuit Failure.
1. Place ignition switch in OFF
position and disconnect
actuator harness from engine
ECU.
a. Inspect actuator harness
Clean and repair connector(s) as
required (WP 0113 00).
and ECU connector for
dirty,
corroded, bent,
broken, pushed back, and
extended pins.
b. Check actuator harness and
Remove dirt and moisture from
ECU connector for dirt or
connector. Replace missing or
damaged connector seals (WP
moisture in or on connector
0113 00).
and for missing or damaged
connector seals.
2. Place ignition switch in OFF
position and disconnect
actuator harness from engine
ECU and 15-pin connector at
front of engine below rocker
arm cover. Install jumper wire
from pin 5 to pin 6 at 15-pin
connector, actuator harness
side.
3. Measure resistance from
a. If resistance is not as
actuator harness connector
specified, repair or replace
connectors (WP 0113 00).
pin 6 to pin 16. Resistance
b. If engine harness requires
should be less than 10 Ohms.
replacement, notify SRA.
0008 00-38
