TM 10-3930-675-24-1
ENGINE OIL PRESSURE SENSOR TROUBLESHOOTING - CONTINUED
0020 00
Table 1. Error Code 1135 - Oil Pressure Sensor Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1135 - Oil Pressure Sensor Circuit 7. Measure supply voltage from If voltage is not as specified,
Failure - Continued.
pin C (or YELLOW) to pin B proceed with the following steps.
(or BLACK) of breakout
cable. Voltage should be 0.50
to 1.40V.
0.50-1.40V
8. Ensure ignition switch is in
OFF position. Disconnect
sensor harness from engine
ECU.
a. Inspect sensor harness and Clean and repair connector(s) as
engine ECU connectors for required (WP 0113 00).
dirty,
corroded,
bent,
broken, and pushed back or
extended pins.
b. Check sensor harness and
Remove dirt and moisture from
engine ECU for dirt or
connector. Replace missing or
moisture in or on connectors
damaged connector seals (WP
and for missing or damaged
0113 00).
connector seals.
0020 00-4
