TM 10-3930-675-24-2
ENGINE ELECTRONIC CONTROL MODULE (ECM) REPLACEMENT - CONTINUED
0079 00
INSTALLATION - CONTINUED
3.
Position actuator harness connector (6), sensor harness connector (8), and 32-pin connector (12) with bracket (10).
4.
Install screw (9) and washer (3) to secure bracket (10) to ECM (5). Tighten captive screws (13) to 25 lb-in. (3 Nm) to
secure connectors.
5.
Position engine wiring harness (14) and OEM wiring harness. Secure engine wiring harness with cable clamp (1), screw
(2), and washer (3). Tighten captive screw (13) on OEM wiring harness to 25 lb-in. (3 Nm).
6.
Connect wiring harness (11) to 32-pin connector (12).
7.
Fully tighten ECM screws (2 and 9) evenly to 180 lb-in. (20 Nm).
8.
Install engine cover (WP 0148 00).
END OF WORK PACKAGE
0079 00-3/(0079 00-4 Blank)
