TM 10-3930-675-24-2
TRANSMISSION SENSORS REPLACEMENT - CONTINUED
0096 00
INSTALLATION
CAUTION
Spacers removed with sensors must be reinstalled with same sensor. If sensor is replaced, spacer must
be replaced with the same type and quantity when installing sensor. Failure to follow this caution may
result in damage to equipment or improper sensor operation.
NOTE
If reinstalling sensor, ensure new O-ring seal is used. If installing new sensor, ensure new O-ring pro-
vided is installed.
1.
Install sensor with new O-ring in transmission. Tighten sensors as follows:
a.
Outspeed speed sensor: 204 lb-in. (23 Nm)
b.
All other sensors: 265 lb-in. (30 Nm)
SENSOR
O-RING
NOTE
Ensure connector and sensor key are aligned prior to connection.
2.
Connect electrical connector to sensor.
0096 00-4