TM 10-3930-675-24-2
ELECTRICAL GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
0113 00
RECEPTACLE CONNECTOR REPAIR - CONTINUED
15
16
17 18
19
20
5.
Using wire stripping tool, strip insulation off wire (16) to expose -in. (6-mm) length of metal strands (17).
6.
Using crimping tool, securely crimp tabs (19) of receptacle (20) over metal strands (17).
7.
Using crimping tool, crimp tabs (18) of receptacle (20) over insulation of wire (16).
8.
Slide connector (15) forward over receptacle (20) until locking tab of receptacle snaps into place.
WATERPROOF CONNECTOR REPAIR
1.
Remove end cover (27) and gasket (26) from front of connector (25).
2.
Remove seal (21) from rear of connector (25) and slide seal back on wire (22).
21
25
26
22
23
24
27
NOTE
Perform steps 3 thru 9 for each wire of connector.
Tag wires for installation.
3.
Using pin removal tool, insert tool into front of connector (25) and depress locking tab of connector.
4.
Remove wire (22) with pin (24) from rear of connector (25).
5.
If defective, remove pin (24) from wire (22) by cutting through wire just behind pin.
6.
Using wire stripping tool, strip insulation off wire (22) to expose -in. (6-mm) length of metal strands (23).
0113 00-5