TM 10-3930-675-24-2
FRONT AND REAR PROPELLER SHAFTS REPLACEMENT - CONTINUED
0120 00
REAR PROPELLER SHAFT REMOVAL - CONTINUED
NOTE
Perform the following steps at rear of rear propeller shaft.
3.
Remove 12 locknuts (14) and lockwashers (15) from flange of propeller shaft (13). Discard locknuts and lockwashers.
4.
Remove propeller shaft (13) from studs of parking brake disc (16) on rear axle (17) and remove propeller shaft from
vehicle.
13
14,15
17
16
REAR PROPELLER SHAFT INSTALLATION
NOTE
Perform the following steps at rear of rear propeller shaft.
Ensure witness marks are aligned.
1.
Position propeller shaft (13) on studs of parking brake disc (16) on rear axle (17).
2.
Install 12 new lockwashers (15) and new locknuts (14). Tighten locknuts to 85 lb-ft (115 Nm).
NOTE
Perform the following steps at front of rear propeller shaft.
3.
Position propeller shaft (13) on flange of transmission (9).
4.
Install 12 screws (10), new lockwashers (11), and new locknuts (12). Tighten locknuts to 85 lb-ft (115 Nm).
0120 00-4
