TM 10-3930-675-24-2
FRONT AND REAR AXLE STEERING CYLINDERS REPLACEMENT - CONTINUED
0135 00
REMOVAL
1.
Disconnect two hydraulic hoses (3) from two elbows (4).
2.
Cap/plug both hydraulic hoses (3).
3.
Loosen jamnuts (5) and remove two elbows (4).
4.
Remove bolt (8) and washer (9).
5.
Using a hammer, tap out shaft (1) and remove grease fitting (2).
6.
Remove and discard two O-rings (7).
7.
Repeat steps 4 thru 6 for opposite end of cylinder (6).
8.
Remove cylinder (6).
2
4
3
5
1
8,9
6
7
INSTALLATION
NOTE
hydraulic hoses and applying proper torque.
1.
Lubricate two new O-rings (7) with lubricating oil.
2.
Apply antiseize compound to shaft (1).
3.
Align cylinder (6) end and two O-rings (7) on mounting bracket so shaft (1) can be installed.
4.
Tap shaft (1) into place using hammer and install grease fitting (2).
5.
Install washer (9) and bolt (8).
6.
Repeat steps 1 thru 5 for opposite end of cylinder (6).
7.
Install two elbows (4) and tighten jamnuts (5).
8.
Remove cap/plug from two hydraulic hoses (3) and install hoses on two elbows (4).
0135 00-2
