TM 10-3930-675-24-2
FENDER ASSEMBLY REPLACEMENT (ARMY, RESET, AND USMC) - CONTINUED
0149 00
FRONT FENDERS AND FENDER BRACKETS INSTALLATION (USMC)
NOTE
Rear fender support brackets can be installed with lights and light brackets attached.
1.
Install fender support bracket (1) with eight screws (14) and new lockwashers (15).
2.
Connect waterproof connector (22) to inside base of fender support bracket (1).
3.
Position fender (10) on fender support bracket (1).
4.
At rear of fender, install six locknuts (16), screws (17), and twelve washers (18). At front fender, install three locknuts
(19), screws (20), and six washers (21).
FENDER BRACKET MOUNTING PLATE REMOVAL AND INSTALLATION
(ALL VEHICLE CONFIGURATIONS)
Fender Bracket Mounting Plates Removal
NOTE
Fenders and fender brackets must be removed prior to removing plates.
1.
Perform steps 2 and 3 of WP 0104 00-2 and set wheel sensor and bracket aside.
2.
Remove six front (1) or eight rear (2) socket head capscrews to free fender bracket mounting plate (3) from axle.
2
3
1
3
434-40185
434-40184
Fender Bracket Mounting Plate Installation
1.
Clean surface of axle and mounting plate (3) and transfer grease fittings from old plate to new plate.
2.
Apply RTV to bolt circle on axle, and install fender bracket mounting plate (3) and secure with six front (1) or eight rear
(2) socket head capscrews.
3.
Perform steps 8 and 9 of WP 0104 00-6 to install wheel sensor.
END OF WORK PACKAGE
0149 00-9/(0149 00-10 Blank)
