TM 10-3930-675-24-2
SPREADER CHAIN REPLACEMENT - CONTINUED
0168 00
REMOVAL - CONTINUED
12.
Return to end of tophandler where chain is being replaced and slowly pull sliding beam out of main beam until it reaches
40-ft stop block (34).
13.
Remove four capscrews (25) and washers (26) from hydraulic/electrical hose power track support (27), allow support to
hang loose.
14.
Remove four socket head capscrews (29), washers (30), and locknuts (31), from other end of hydraulic hose/electric
power track (28) to allow enough slack to continue to slide beam outward. Discard locknuts.
28
27
25,26
29,30
31
434-40194
434-40193
15.
Mark position (C) of 40-ft stop block (34) for repositioning during reassembly. Remove four capscrews (32), washers
(33), and stop block (34) and slowly pull sliding beam out another 2.5 ft (76.2 cm) to access chain anchor (35).
16.
Remove cotter pin (37), washer (38), and pin (36) from chain (13). Discard cotter pin.
36
32,33
35
13
34
434-40195
434-40137
37,38
0168 00-7
