TM 10-3930-675-24-2
CAB TRANSPORT HYDRAULIC HOSES AND FITTINGS REPLACEMENT - CONTINUED
0181 00
CAUTION
Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all open-
ings after disconnecting. Contamination of hydraulic system could result in equipment failure.
If replacing hydraulic line coming from bottom of reservoir, close ball valve at reservoir so reser-
voir need not be drained. After installation of hydraulic line, be sure to open ball valve to restore
hydraulic fluid flow. Failure to do so will damage equipment.
NOTE
Tag all hydraulic lines.
REMOVAL
1.
Using illustration (refer to foldout, FO-10 at the end of this manual) as a guide, remove damaged hose(s) or fitting(s).
Cap or plug openings.
NOTE
Note position of tiedown straps and clamps to aid in installation.
2.
Remove tiedown strap(s) and clamp(s) (if applicable). Discard tiedown strap(s).
3.
Remove and discard O-ring(s).
INSTALLATION
NOTE
Refer to General Maintenance Instructions (WP 0284 00) for complete instructions on connecting
hydraulic hoses and applying proper torque.
1.
Lubricate and install new O-ring(s).
2.
Remove caps/plugs and install and tighten hose(s) or fitting(s).
3.
Install clamp(s) and new tiedown strap(s) (if applicable) in same position as noted during removal.
4.
Open any ball valve at hydraulic reservoir that was closed.
5.
6.
Start engine (TM 10-3930-675-10) and check for leaks.
NOTE
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE
0181 00-2