TM 10-3930-675-24-2
STEERING CALIBRATION - CONTINUED
0238 00
CALIBRATION - CONTINUED
6.
Steering Cylinder No. 2 Calibration (Menu 5 of 10).
a.
Steering cylinder position must be manually checked by measuring cylinder length. Measurement should be taken
from center-to-center of cylinder mounting pins. Correct length is 34 in. (868 mm). If length is incorrect, adjust
steering cylinder for wheel no. 2 (RR) by pressing increase "+" or decrease "-" buttons.
b.
Press "Enter".
c.
Recheck steering cylinder position. Correct length should be 34 in. (868 mm).
d.
ECS display screen should look as shown:
CALIBR STEERING
5 (10)
AXLE 2
SET WHEEL
0
ANGLE
0
e.
Press right arrow button to advance through remaining steering system calibration menus.
Steering System Hydraulic and Electrical Connections Check (Menu 6 of 10).
7.
a.
Pressing value increase "+" button will result in wheel no. 3 (LR) moving right and an increase of values on ECS
display screen.
b.
Pressing value decrease "-" button will result in wheel no. 3 moving left and a decrease of values on ECS display
screen. ECS display screen should look as shown:
CALIBR STEERING
6 (10)
AXLE 3
Range 0 +/-5
ADJUST WHEEL
0
ANGLE
0
c.
Press right arrow button to advance through remaining steering system calibration menus.
Steering Cylinder No. 3 Calibration (Menu 7 of 10).
8.
a.
Steering cylinder position must be manually checked by measuring cylinder length. Measurement should be taken
from center-to-center of cylinder mounting pins. Correct length is 34 in. (868 mm). If length is incorrect, adjust
steering cylinder for wheel no. 3 (LR) by pressing increase "+" or decrease "-" buttons.
b.
Press "Enter".
c.
Recheck steering cylinder position. Correct length should be 34 in. (868 mm).
d.
ECS display screen should look as shown:
CALIBR STEERING
7 (10)
AXLE 3
SET WHEEL
0
ANGLE
0
e.
Press right arrow button to advance through remaining steering system calibration menus.
0238 00-3
