INTRODUCTION
Explanation
1. Scope
P
Repair parts, special tools and test equipment supplied
This manual lists repair parts, special tools, test
from the GSA/DSA, or Army supply system, and
and support equipment required for the performance
authorized for use at indicated maintenance cate-
of organizational, direct support, general support
gories.
P2
Repair parts, special tools and test equipment which
maintenance of the container.
are procured and stocked for insurance purposes
because the combat or military essentiality of the
2. General
end item dictated that a minimum quantity be
This Repair Parts and Special Tools List is divided into
available in the supply system.
the following sections:
M
Repair parts, special tools and test equipment which
are not procured or stocked, as such, in the supply
a. Prescribed Load Allowance (PLA) -- Section II. A
system but are to be manufactured at indicated
composite listing of repair parts, special tools, test
and support equipment having quantitative allow-
A
Assemblies which are not procured or stocked as such,
ances for initial stockage at the organizational level.
hut are made up of two or more units. Such com-
ponent units carry individual stock number and
descriptions, are procured and stocked separately
authorized for the performance of maintenance at
and can be assembled to form the required assem-
the organizational level in figure and item number
bly at indicated maintenance categories.
sequence.
X
Parts and assemblies that are not procured or stocked
c. Special Tools, Test and Support Equipment --
because the failure rate is normally below that of
Section IV. A list of special tools, test and support
the applicable end item or component. The failure
of such part or assembly should result in retire-
equipment authorized for the performance of main-
ment of the end item from the supply system.
tenance at the organizational level. (Not applicable).
Xl
Repair parts which are not procured or stocked. The re-
quirement for such items will be filled by the next
authorized for the performance of maintenance at
higher assembly or component.
the direct support, general support level in figure
X2
Repair parts, special tools and test equipment which
and item number sequence.
are not stocked and have no foreseen mortality.
The indicated maintenance category requiring such
e. Special Tools, Test and Support Equipment --
r e p a i r parts will attempt to obtain the parts
Section VI. A list of special tools, test and support
through cannibalization or salvage, the item may
equipment authorized for the performance of main-
be requisitioned with exception data, from the end
tenance at the direct support, general support, and
item manager, for immediate use.
depot level. (Not applicable).
G
Major assemblies that are procured with PEMA
funds for initial issue only as exchange assemblies
f. Federal Stock Number and Reference Number
at DSU and GSU level. These assemblies will not be
stocked above the DS and GS level or returned to
in ascending numerical sequence, followed by a list
depot supply level.
of reference numbers appearing in all of the listings,
Maintenance code indicates the lowest cate-
in alphanumeric sequence, cross-referenced to the
(2)
gory of maintenance authorized to install the listed
illustration figure number and item number.
item. The maintenance codes are:
Note. Items not illustrated are cross-referenced to group
number.
Explanation
Code
Organizational maintenance
O
F
Direct support maintenance
The following provides an explanation of columns
H
General support maintenance
in the tabular lists in sections II through VI.
Recoverability code indicates whether un-
(3)
a. Source, Maintenance, and Recoverability Codes
serviceable items should be returned for recovery
(SMR).
or salvage. Items not coded are expandable. Re-
Note. Common hardware items known to be readily available
coverability codes are:
in Army supply channels are assigned Maintenance codes only.
Source codes, Recoverability codes, and Maintenance Allowances
Explanation
are not assigned to this category.
Code
(1) Source code indicates the selection status
R
Applied to repair parts, (assemblies and components)
and source for the listed item. Source codes used are:
special tools and test equipment which are con-
iii
