TM 5-3810-306-34
10. REMOVE SPUR GEAR (62).
NOTE
a. Remove retaining ring (61).
Special ring (56) remains in housing
(52).
b. Remove spur gear (62).
15. REMOVE RETAINING PLATE (24).
11. REMOVE SHAFT (66).
a. Remove six screws
(20),
nut
(21)
and
a. Remove retaining ring (63).
lockwasher (22).
b. Press shaft (66) from stator support (67).
b. Remove retaining plate (24) and packing (25).
Discard packing (25).
c.
Remove bearing (64).
16. REMOVE THREE COUPLINGS (26).
d. Remove and discard ring seal (65) and piston
rings (70) and (71).
NOTE
12. REMOVE RETAINER (52).
Remove couplings
(26)
if
not
removed with pump.
a. Remove three machine
bolts
(48)
and
lockwashers (49).
17. REMOVE THREE GEARSHAFTS (30).
b. Remove two nuts (50) and lockwashers (51).
a. Remove retaining rings (27) and spacer rings
(28).
c.
Remove retainer (52) and preformed packing
(54). Discard packing (54).
NOTE
d. Remove seal (47).
Mark location of longer gearshaft for
reassembly.
13. REMOVE YOKE (46).
b. Remove gearshafts (30).
a. Secure shaft (57) in vise with protected jaws.
c.
Remove retaining rings (29) and (31).
b. Remove nut (43), washer (44) and preformed
packing (45). Discard packing (45).
d. Press bearings (32) and (34) and spacers (33)
from gearshafts (30).
c.
Remove yoke (46).
18. REMOVE VALVE (2).
14. REMOVE SHAFT (57).
NOTE
a. Expand special ring (56) and remove shaft (57)
with bearings (55) and (59).
Use care to avoid losing seat (10),
plunger (13) and spring (14) when
b. Remove retaining ring (60), bearing (59), spur
removing valve (2).
gear (58) and bearing (55).
a. Remove four capscrews with washers (12) and
valve (2).
b. Remove and discard preformed packing (15)
and gasket (16).
7-8
