TM 5-3810-306-34
d. Install new preformed packing (54) in retainer
e. Tap gearshafts (30) until retaining rings (29)
(52).
shoulder against bearing bore.
e. Install retainer assembly (52) in converter
f.
Install spacer ring (28) and retaining ring (27).
housing (40).
4. INSTALL SHAFT (57).
f.
Install three machine bolts (48) with new
a. Press oil seal (47) into retainer (52). Press seal
lockwashers (49).
from inside of retainer to dimension shown.
g. Install two nuts (50) with new lockwashers (51).
h. Torque machine bolts (48) and nuts (50) to 37-
41 ft-lbs. (49-55 Nm).
6. INSTALL SHAFT (66).
a. Press bearing (64) on shaft (66).
CAUTION
Use care to avoid damage to seal ring
(65).
b. Press bearing (55) on shaft (57) and special ring
(56).
b. Install new seal ring (65).
CAUTION
c.
Press shaft (66) into stator support (67).
Use care to avoid damage to oil seal
d. Install retaining ring (63).
(47).
7. INSTALL SPUR GEAR (62).
c.
Press shaft (57) into retainer (52).
a. Install spur gear (62) on shaft (66) with large
d. Install spur gear (58) on shaft (57).
shoulder toward bearing.
e. Press bearing (59) on shaft (57) and install
b. Install retaining ring (61).
retaining ring (60).
8. INSTALL STATOR SUPPORT (67).
5. INSTALL RETAINER (52).
CAUTION
a. Secure shaft (57) in vise equipped with soft jaws.
Spring gap on piston rings (70) and
b. Install yoke (46), new preformed packing (45),
(71) should be 180 from piston ring
washer (44) and nut (43).
hook joint.
c.
Torque nut (43) to 200-250 ft-lbs (271-338 Nm).
a. Install piston rings (70) and (71) on stator
support (67).
7-12
