TM 5-3810-306-34
b. Install stator support (67) in housing (40).
NOTE
c. Install six capscrews (69) with lockwashers (68).
Do not tighten bolts (37).
d. Torque capscrews to 57-63 ft-lbs. (76-84 Nm).
j. Rotate long gear shaft (30) to align gears (41)
and (73).
9.
INSTALL THREE SPUR GEARS (41).
k. Tighten bolts (37) in alternate pattern using care
a. Install spur gears (41) with P/N facing away from
to evenly seat oil baffle (75). Torque bolts (37)
inner housing (40).
to 23-25 ft-lbs. (3033 Nm).
b. Install retaining rings (42).
11.
INSTALL REACTION MEMBER (85).
10.
ASSEMBLE OIL BAFFLE (75) AND IMPELLER
a. Install spacer (84).
(79).
b. Install reaction member (85) on impeller (79).
a. Press seal (76) in oil baffle (75) with lip of seal
away from impeller (79).
c. Install retaining ring (86).
b. Press bearing (82) in hub (81).
d. Install retaining ring (87).
c. Install retaining ring (83).
12.
INSTALL TURBINE (89).
d. Install new preformed packing (80) on hub (81).
a. Apply locktite to capscrews (91). Assemble
turbine (89) and hub (88). Position spacer plate
e. Apply locktite to twelve bolts (77). Position hub
(90) and secure with capscrews (91). Torque
(81) in impeller (79), position spacer plate (78)
capscrews (91) to 40 in-lbs. (4 Nm). Lockwire
and secure with twelve bolts (77). Torque bolts
capscrews (91) in pairs.
(77) to 40 in-lbs. (4 Nm).
b. Install turbine (89) with hub (88).
f. Install oil baffle (75) on impeller (79).
c. Install retaining ring (92).
g. Install gear (73) and retaining ring (72).
13.
ASSEMBLE IMPELLER COVER (96).
h. Set impeller (79) and oil baffle (75) in housing
(40), aligning three bolt holes in baffle with holes
a. Press bearing (95) into impeller cover (96).
in housing.
b. Install retaining ring (94).
i. Start three bolts (37) with new lockwashers (38)
thru housing (40) into oil baffle (75).
c. Heat sleeve (98) to 200F (93C) and press on
impeller cover (96).
14.
INSTALL IMPELLER COVER (96).
a. Install new preformed packing (93) on impeller
cover (96).
7-16
