TM 5-3810-306-34
a. Position valve section (42) on valve body (10)
NOTE
and install capscrews (43) and (44) through
valve section (42) and valve body (10).
The valve should turn by hand until
compression of the packings begins.
b. Install valve section (9) over cap screws (43) and
(44), and install nuts (46).
1.
REMOVE ANY BURRS FROM FACES OF
VALVE SECTIONS AND ENSURE ALL MATING
6.
INSTALL SAFETY RELIEF VALVES (13) AND
SURFACES ARE CLEAN.
(24).
2.
IF REMOVED, INSTALL PLUG (22) IN VALVE
a. Install new packings (25), (26) and (27) on relief
BODY (10).
valve (24).
b. Install relief valve (24) in valve body (10).
3.
ASSEMBLY VALVE SECTION (42).
c. Install new packing (14) and relief valve (13) in
a. Install plugs (38) and (39), and new packing
valve body (10).
(40).
7.
INSTALL VALVES (15).
b. Install new packings (47), (48) and (49) on
directional sleeve (45).
a. Install new packings (16), (17) and (20), and new
retaining rings (18) and (19) on valves (15).
c. Install directional sleeve (45) in valve section
(42).
d. Install relief valve (41) in valve section (42).
8.
INSTALL SOLENOIDS (31).
e. Install new packings (35), (36) and (37) in valve
a. Install valve (21), new packings (23), washers
section (42).
(28) and springs (29) in valve body (10).
4.
ASSEMBLE VALVE SECTION (9).
b. Install new packings (30) in solenoids (31).
a. Install new packing (8) and plug (7) in valve
c. Install solenoids (31) on valve body (10) with
section (9).
socket head screws (32) and (33).
b. Install new packings (4), (5) and (6) on
9.
INSTALL
INTEGRATED
OUTRIGGER
directional sleeve (3).
CONTROL VALVE. (REFER TO TM 53810-306-
20.)
c. Install directional sleeve (3) in valve section (9).
END OF TASK
d. Install new packings (11) and
(12) in valve
section (9).
5.
INSTALL VALVE SECTIONS (9) AND (42).
13-56