TM 5-3810-306-34
b. Apply Loctite 271 to shaft seal (4) and install in
CLEANING AND INSPECTION:
mounting flange (8).
WARNING
c. Install shaft (2).
Dry cleaning solvent P-D680 is
d. Install spacer (7), key (3) and gear (11) onto
toxic and flammable.
Wear
shaft (2). Secure with retaining ring (12).
protective goggles and gloves
and use only in a well ventilated
2. INSTALL MOUNTING FLANGE (8).
area. Avoid contact with skin,
eyes, and clothes and do not
a. Install a new preformed packing (13) lubricated
breathe vapors. Do not use near
with clean hydraulic oil, into brake housing (17).
open flame or excessive Heat.
The flash point is 100F-138F
NOTE
(38-59C). If you become dizzy
while using cleaning solvent, get
Apply Loctite 242 to all bolts.
fresh air immediately and get
medical aid. If contact with eyes
b. Install mounting flange (8) onto brake housing
is made, wash your eyes with
(17) with bolts (9) and washers (10). Torque
water and get medical aid
bolts (9) to 31 ft-lbs (41 Nm).
immediately.
NOTE
Compressed air used for cleaning
purposes will not exceed 30 psi.
Ensure
proper
order
is
Use only with effective chip
maintained
(stator
with
guarding and personal protective
external teeth, then brake disc
equipment
(goggles/shield,
(18) with internal teeth, etc.).
gloves, etc.).
3. INSTALL THE BRAKE DISCS (18) AND STATORS
1. CLEAN ALL PARTS WITH SOLVENT P-D-680 AND
(19) OVER GEAR.
BLOW DRY WITH COMPRESSED AIR.
4. INSTALL PISTON
(15)
AND
PREFORMED
2. INSPECT ALL PARTS FOR CRACKS AND
PACKING (13).
EXCESS WEAR, REPLACE AS NECESSARY.
a. Install a new preformed packing (13) lubricated
REASSEMBLY:
with clean hydraulic oil, into packing groove on
inside of brake housing (17).
1. INSTALL BEARING (6), SHAFT (2) AND GEAR
(11).
b. Install new preformed packings (13) lubricated
with clean hydraulic oil, onto brake piston (15).
a. Position bearing (6) in mounting flange (8) and
secure with retaining ring (5).
15-128
