TM 55-8145-201-14
4-24. EXHAUST ,LINE REPLACEMENT.
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools:
References:
General Mechanics Tool Kit (Item 4, App 13)
TM 9-4110-252-14
Material/Parts:
TM 5-6115-585-12/34
Self locking nut (6) (Item 13, App F)
Equipment Condition :
Refrigeration unit shutdown (TM 9-4110-252-14)
Generator set shutdown (TM 5-6115-585-12/34)
a. Removal.
WARNING
To prevent injury to personnel, allow generator set and exhaust lines to cool
before removal.
(1) Disconnect exhaust coupling (12 and 13) from generator set (TM 5-6115-585- 12/34).
(2) Remove nuts (7 and 8), screws (16 and 19), and rings (17 and 20) from screen (18).
(3) Remove screen (18) from exhaust tubes (11 and 14).
(4) Remove two nuts (10), spacer (9), and clamp (15) from exhaust tubes (11 and 14).
(5) Remove two nuts (6),spacer (5), and clamp (21) from exhaust tubes (11 and 14).
(6) Remove two nuts (4),spacer (22), and clamp (24) from exhaust tubes (11 and 14).
(7) Remove exhaust tubes (11 and 14) from container frame (27).
(8) Remove two nuts (3), flat washers (2), screws (1) and bracket (23) from container frame (27).
(9) Loosen screw (26) and remove cap (25) from bracket (23).
b. Installation.
(1) Position cap (25) on bracket (23) and tighten screw (26).
(2) Position bracket (23) on container frame (27) and install two flat washers (2), screws (1) and nuts (3).
(3) Position exhaust tubes (11 and 14) in container frame (27). Make sure upper ends of both tubes extend
into bracket (23).
(5) Install spacer (22), clamp (24), and two nuts (4) on exhaust tubes (11 and 14).
4-36