STARTER MOTOR DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 12 of 13)
12. Armature (46)
Place the thrust washer (45) on the commutator
end of the armature.
Place the end plate and brush holder assembly
Grease should be applied to the commutator end
(59) onto the armature.
bushing surface and the armature shaft splines
13. Brushes (62)
Place the brushes (62) in the holders.
Place over the splined shaft end.
15. Armature and end plate
Install into the frame assembly and secure
If original parts are used, aline the marks which
with screws and washers.
you scribed on the housings before disassembly.
16. Inspection plug (34)
Install new gaskets and inspection plugs.
Go on to Sheet 13