TM 10-3930-641-34-1
CRANKSHAFT SEALS REPLACEMENT (CONT)
(Sheet 3 of 7)
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION
1. Wear sleeve (1), crankshaft (2)
a. Apply quick cure primer to wear sleeve
CRANKSHAFT
inside diameter and crankshaft outside
SEAL AND WEAR
diameter.
SLEEVE INSTALLATION
TOOL
b. After primer has set, apply retaining
compound to wear sleeve inside diameter
and crankshaft outside diameter.
2. Locator (3), bolts
Install on front of crankshaft.
3. Front seal (4), wear sleeve (1)
a. Coat lip of front seal and outside diameter
of wear sleeve with clean engine oil.
b. Install front seal on wear sleeve.
NOTE
Make sure lip of seal is toward inside of engine
and outside diameter bevel of wear sleeve is
toward outside of engine.
c. Put wear sleeve and front seal in position
on locator.
TA099133
Go on to Sheet 4
3-333