TRANSMISSION ASSEMBLY HYDRAULIC HOSES AND PIPES REPLACEMENT - CONTINUED
REMOVAL - CONTINUED
NO. 3 & NO. 6
NO. 7 & NO. 12
NO. 2, 4 & 5
TRANSMISSION ASSEMBLY HOSE
AND PIPE LOCATION DIAGRAM
Refer to General Maintenance Instructions (WP 0284 00) for complete instructions on connecting
hydraulic hoses and pipes and applying proper torque.
If adapter fitting and O-ring seal have been removed, perform steps 1 and 2. If not, proceed to
Apply lubricating oil to new O-ring seal and install on adapter fitting.
Install adapter fitting on transmission.
Connect hose to adapter fitting and route hose to opposite end as indicated on location diagram.
Apply lubricating oil to two new O-rings.
Install hose connection and two O-rings on transmission and secure with fluid passage bolt.
Secure hydraulic hose with new tiedown straps as needed.
Position pipe (8, 9, 10, or 11) on transmission and tighten each of two fitting nuts.
Operate vehicle and check for leaks (TM 10-3930-675-10).
Return cab to operational position (TM 10-3930-675-10).
END OF WORK PACKAGE
0116 00-3/(0116 00-4 Blank)