CAB TRANSPORT LIFT MAINTENANCE - CONTINUED
CAB ADJUSTMENT: TRANSPORT POSITION - CONTINUED
At right rear of cab and at frame, observe clearance between proximity switch guard (30) and vehicle frame. Proximity
switch guard should be as close as possible to, but not applying pressure on frame.
Move cab back to operational position.
Tag or mark shims, nuts, and washers to ensure the same order of replacement during installa-
Mark position of receptacle before loosening nuts.
Use one of the cab pins as a guide when aligning the two receptacle halves when tightening the
Loosen bolts (34) and nuts (31) on front and rear, right-side transport receptacles (33).
Remove and discard two nuts (31) and washers (32) from receptacles (33).
Install two new nuts (31) and washers (32) and tighten bolts (34) enough to allow for adjustment.