CYLINDER HEAD REPAIR - CONTINUED
DISASSEMBLY - CONTINUED
DO NOT remove components in steps 7 thru 9 unless they do not meet inspection standards.
Refer to Inspection for details.
If valve guide does not meet inspection standards, remove valve guide. Step 7 will remove one
valve guide. Any damaged valve guide is removed in the same manner.
Insert valve guide removal tool (9) from combustion surface side and drive valve guide (10) and valve guide seal (11)
out of cylinder head (2). Discard seal.
If valve seat insert is defective, remove in the following manner. Any damaged or defective valve seat
insert is removed in the same manner.
Install valve seat extractor (12) and slide hammer (13) on defective valve seat insert (14). Remove and discard valve seat