TM 5-3810-306-34
NOTE
Aligning discarded seals and rings in
order of disassembly will facilitate
installation of new items.
c.
Remove seals (5) and ring (6) from outside of
piston.
2. REMOVE HEAD (9) FROM ROD AND PISTON (14).
REMOVE SEALS FROM HEAD.
a. Remove packing (7) and back-up ring (8) from
outside of head.
b. Remove wear ring (10), rod seal (12) and buffer
seal (11) from inside of head.
c.
Remove wiper seal (13) from head.
d. If necessary, remove cap (4).
CLEANING AND INSPECTION:
WARNING
WARNING
Dry cleaning solvent P-D-680 is toxic
and flammable.
Wear protective
Compressed air used for cleaning
goggles and gloves and use only in a
purposes will not exceed 30 psi. Use
well ventilated area. Avoid contact
only with effective chip guarding and
with skin, eyes, and clothes and do
personal
protective
equipment
not breathe vapors. Do not use near
(goggles/shield, gloves, etc.).
open flame or excessive heat. The
flash point is 100F-138F (380-590C).
1. CLEAN ALL PARTS WITH SOLVENT AND DRY
If you become dizzy while using
WITH COMPRESSED AIR. INSPECT ALL PARTS
cleaning solvent, get fresh air
FOR SERVICEABILITY.
immediately and get medical aid. If
contact with eyes is made, wash your
CAUTION
eyes with water and get medical aid
immediately.
Before installing new seals and rings,
clean all surfaces and carefully
remove burrs and nicks.
Parts
displaying excessive wear or damage
should be replaced.
2. STONE OUT MINOR BLEMISHES AND POLISH
WITH A FINE CROCUS CLOTH.
13-89