TM 5-3810-306-34
MAIN HOIST INSTALLATION
Overhead hoist (1 ton Capacity)
SUPPLIES:
EQUIPMENT CONDITION: Wire rope removed from hoist drum.
(Refer to TM 5-3810-306-20.)
Hydraulic system shutdown and pressure relieved from lines.
(Refer to TM 5-3810-306-20.)
Negative battery cable disconnected at shunt.
(Refer to TM 5-3810-306-20.)
REMOVAL:
WARNING
1. TAG AND REMOVE HYDRAULIC LINES TO HOIST
Hoist weighs approximately 1800
(1).
pounds (818 kg). Use care when
lifting and transporting.
(5) securing clamps on hydraulic tubes (2) and
b. Using suitable lifting device, remove hoist from
(3). Remove two hydraulic tubes and preformed
crane.
packings (6). Discard packings (6).
INSTALLATION:
b. Disconnect fitting (7) at end of case drain tube.
Remove tube and preformed packing (8).
1. INSTALL MAIN HOIST (1).
Discard packing (8).
a. Using suitable lifting device, position main hoist
c.
Disconnect fitting (9) at motor drain tube.
(1) onto turntable.
Remove tube and preformed packing (10).
Discard packing (10).
b. Install four capscrews (11), washers (12) and
nuts (13) and secure hoist (1) to turntable.
2. REMOVE MAIN HOIST (1).
c.
Using suitable torque wrench, torque nuts (13) to
a. Remove four capscrews (11), washers (12) and
1100 ft-lbs (1465 Nm).
nuts (13) securing hoist assembly (1) to
turntable.
15-34