TM 10-3930-641-10
OPERATION UNDER USUAL CONDITIONS - CONTINUED
0005 00
OPERATE MACHINE - CONTINUED
4.
Stopping/Parking RTCH.
a.
Release accelerator pedal to reduce engine speed.
WARNING
DO NOT use parking brake to stop a moving machine under usual conditions.
Only if service brakes fail, apply parking brake. Failure to follow these warnings may result in injury or
death to personnel or damage to equipment.
b.
Apply right brake pedal to stop machine. Select a level surface to stop/park if possible.
c.
Move transmission range selector to neutral.
WARNING
NEVER leave operator compartment without applying parking brake. Failure to follow this warning may
cause injury or death to personnel in the event machine moves inadvertently when parked.
d.
Apply parking brake by pulling out on parking brake control knob.
e.
Lower forks/tophandler to the ground by pushing lift control lever forward.
ENGINE SHUTDOWN
0005 00
CAUTION
Stopping engine immediately after it has been operating under a load can result in overheating and
accelerated wear of engine components.
The following shutdown procedures allow engine to cool. This will prevent excessive temperatures in
turbocharger center housing. Failure to shut down engine properly may cause premature engine failure.
Avoid prolonged idling as this may cause sludge buildup in engine.
NOTE
Refer to WP 0004 00 for the location and operation of controls and indicators.
1.
Operate engine at half speed for five minutes.
2.
Operate engine at low idle for 30 seconds.
3.
Turn power switch off and remove key.
0005 00-8
