TM 10-3930-641-20
(Sheet 3 of 3)
STARTING SOLENOID REMOVAL/INSTALLATION/ADJUSTMENT (CONT)
REMARKS
ACTION
LOCATION/ITEM
Pinion (4) will move to crank position and stay there
c.
3. Pinion(4)(Cont)
until battery is disconnected.
marked MOTOR to ground terminal (6).
d. Push pinion toward starting motor to elim-
inate free movement.
Pinion clearance (Dimension A) should be 0.36 in.
e.
Remove plug (7) and turn nut (8) to adjust
(9.14 mm).
pinion clearance.
Install plug.
f.
Release pinion.
g.
h. Disconnect battery and test wires.
Install with two nuts.
4. Connector(1)
Connect. Be sure to reconnect them in the po-
5. Solenoid wires
sitions marked before they were disconnected.
End
2-263