TM 10-3930-641-20
(Sheet 2 of 2)
WIRING HARNESS REPAIR (CONT)
LOCATION/ITEM
ACTION
REMARKS
Do not try to replace a wire with a gage different than
If wires of a harness are found defective they
1. Wires
that of the original wire.
may be replaced. Sometimes it may be neces-
sary to cut open the wrapping with a sharp
Try to replace the wire with the same color so it will be
knife. After replacing the wire(s) you should
color coded to the manual.
rewrap the group of wires with electrical tape.
At this time it will be necessary to replace the
connectors. See Step 2.
If you splice wires be sure you insulate the connec-
There is a large variety of connectors available.
2. Connector
tion with electrical tape.
Determine which type to use from the old con-
nector. The connector may be fastened by
crimper.
End
2-341