TM 10-3930-641-34-1
ENGINE FRONT SUPPORT AND TRUNNION REMOVAL/INSTALLATION (CONT)
(Sheet 11 of 11)
LOCATION/ITEM
ACTION
REMARKS
55. Mounting capscrews (51) and caps (50)
Remove from each side of engine.
(Two on
front, four on rear.)
56. Engine shield plate
Remove to allow hoist attachment.
WARNING
Do not put an overload on ratchet puller when
engine and torque converter are being removed.
57.
Engine
and
converter
a. Fasten hoist securely to lifting eyes as shown
at right.
b.
Use ratchet puller to make converter and
engine level as shown.
c. Remove engine and converter from chassis.
NOTE
Engine and converter weight is 5,500 lb. (2495
Kg.)
d. Place engine on suitable stand.
NOTE
Attach hoist to beam so that chain at front of
engine (fan end) is farther out on beam than
chain at rear end. Usually a difference of two
hole positions is correct.
3-16
