TM 10-3930-641-34-1
GOVERNOR REMOVAL AND INSTALLATION (CONT)
(Sheet 2 of 4)
LOCATION/ITEM
ACTION
REMARKS
REMOVAL
1. Fuel ratio control (1)
2. Cotter pin (2) and pin (5)
Remove.
3. Governor control cable (4)
Disconnect from lever (3).
4. Capscrews, cover and cover gasket
Remove from governor housing.
5. Allen head capscrew
Remove from stop collar (6).
6. Stop collar (6)
Remove.
7. Timing pin
a. Install in fuel injection pump housing.
b. Be sure correct end is used.
8. Governor control lever (3)
Move until timing pin is in place and racks are
in center (zero) position.
9. Capscrews (8) and governor housing
Remove.
(7)
3-80