TM 10-3930-641-34-1
GOVERNOR DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 9 of 12)
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY
1.
Bearing (88) for drive gear (96)
Using suitable driver, install in governor plate
until bearing is 0.020 in. (0.51 mm) from sur-
face of plate.
2.
Drive gear (96)
Install.
3.
Ring (70)
Install with snap ring pliers.
4.
Valve and piston assembly (74)
Install in sleeve (76).
5.
Preformed packings (75)
Replace on sleeve (76).
6.
Preformed packings (71)
Replace.
7.
Servo piston valve, piston, sleeve and
a. Install through bottom of governor plate.
cylinder assembly (72)
b. Aline notch in cylinder (73) with bolt hole
in governor plate (90).
8.
Spring that returns lever (81)
Install on lever (81).
9.
Lever (81)
a. Position in bracket (83).
b. Install pin (82).
Go on to Sheet 10
3-91