TM 10-3930-641-34-1
GOVERNOR DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 11 of 12)
LOCATION/ITEM
ACTION
REMARKS
19.
Spring washer (10)
Install over governor bolt (62).
NOTE
Concave side of washers should face
up.
20.
Spring (12), spring washer (10), flat
Install.
washer and spring washer (10)
21.
Seat (11)
Install.
22.
Bearing (4)
Using drive plate, install until dimension (Z) is
1.704-1.712 in. (43.28-43.48 mm).
23. Bearing (7)
a. Using drive plate, install until dimension
(X) is 0.993-1.003 in. (25.22-25.48 mm).
b. Dimension (Y) must be 2.380-2.390 in.
(60.45-60.71 mm).
24.
Lip type seals (2) in governor
Install.
housing (5)
NOTE
Lip must point toward inside of housing.
TA099228
Go on to Sheet 12
3-93
