TM 10-3930-641-34-1
ALTERNATOR DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 5 of 7)
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY
1. Bearing race (20)
Install new race on rotor
Use appropriate press and install .08 in. (.20 cm)
past end of shaft.
2. Bearing (19)
Install in rectifier housing
First press in bearing to a depth of .03 in. (0.87 cm)
then press greased seal into a depth of .08 in. (.20 cm).
3. Bearing well plug (17)
Apply grease to bearing and fill bearing
Install plug, using a press.
plug 3/4 with grease. Install bearing plug.
4. Heat sink assembly (29), screws
Install heat sink assembly into rectifier
(9) and washers (31 and 32) and
housing using washers and screws.
insulator (30)
5. Regulator (14)
Install into rectifier housing.
6. Field coil support assembly (21)
Install into rectifier housing using screws.
7. Stator assembly (22)
Install.
Go on to Sheet 6
3-180
