TM 10-3930-641-34-1
CYLINDER LINER REMOVAL/INSTALLATION (CONT)
(Sheet 3 of 7)
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION
1.
Cylinder liner, cylinder block bores
a. Clean in clean non-flammable solvent.
b. Install liners in cylinder block.
NOTE
Spacer plate must be installed for following
operation.
2.
Cylinder liner (projection) height
Check as follows:
a. Install four puller crossbar bolts and
washers (1) around each cylinder liner as
shown at right Tighten the bolts evenly to
a torque of 70 lb.-ft (95 N.m).
b. Install crossbar (2), plate (3), plates (4),
bolts and washers (5) on the first liner to
be measured.
TA099087
Go on to Sheet 4
3-241
