TM 10-3930-641-34-1
CYLINDER LINER REMOVAL/INSTALLATION (CONT)
(Sheet 7 of 7)
LOCATION/ITEM
ACTION
REMARKS
2.
Cylinder liner (projection)
g. If necessary, adjust cylinder liner (projection) - See Cylinder Liner (Projection) Height Adjustment,
height (cont)
height
page 2-86.
3.
Cylinder liners
When (projection) height of each cylinder
liner is determined to be correct, install each
in the following way:
a. Put a mark on cylinder liner and block so
cylinder can be installed in same position.
b. Remove puller crossbar and cylinder liner
projection gage.
c. Remove liner to be installed.
d. Put liquid soap on seals (1), grooves of
liner and bore of block.
End
3-245
